Pro-tek Chrome Frame Slider Yamaha 03-05 YZF-R6 & 06-09 YZF-R6S

$60.00






Yamaha

•2003 2004 & 2005 YZF-R6
•2006 2007 2008 & 2009 YZF-R6S(not R6) 

Frame Sliders are mounted at the middle fairings. Loosen pinch bolt on top of left engine bolt. Remove stock engine mount bolt from left side. Install crash protector with supplied hardware. Left slider is the angled puck using the 10mm x 1.25 x 70mm (shorter) bolt. The right side requires fairing modifications with a one inch hole saw cutter. This is best done by first removing the fairing. Locate the engine mount bolt & replace with the supplied bolt. If heat shield foam is not present, apply playdough to inside fairing where cutting will take place. Put the fairing back and see where the bolt head has left an impression in playdough/heat foam. This is the center of the hole to be drilled. Mask outside of fairing with tape to prevent chipping during drilling. Take 1" hole saw and center around bolt head impression in playdough. Drill through fairing. Lightly file down rough edges around hole. Install slider and replace the fairings.

Includes: (2) Aluminum pucks
              (1) 10mm X 1.25 x 70mm (left side and short puck)
              (1) 10mm x 1.25 x 90mm (right side and long puck)

Add to Cart:

  • Model: AFP-32
  • Shipping Weight: 1lbs
  • 1 Units in Stock
  • Manufactured by: Pro-tek


This product was added to our catalog on Thursday 15 January, 2015.

Your IP Address is: 35.173.234.169
Copyright © 2021 GotTheParts4U. Powered by Zen Cart