Pro-tek Chrome Frame Slider Yamaha 2002 & 2003 YZF-R1 R-1



•2002 & 2003 YZF-R1 R1 

The frame sliders are mounted to the upper engine mounts. The fairings require modification during installation. This is best done by first removing the fairing. Locate the engine mount bolt & replace with the supplied bolt. If heat shield foam is not present, apply playdough to inside fairing where cutting will take place. Put the fairing back and see where the bolt head has left an impression in playdough/heat foam. This is the center of the hole to be drilled. Mask outside of fairing with tape to prevent chipping during drilling. Take 2" hole saw and center around bolt head impression in playdough. Drill through fairing. Lightly file down rough edges around hole. Install short slider and replace the fairings. Only the right side needs modifications. 

Includes: (2) Aluminum pucks 
              (1) 10mm x 1.25 x 60mm bolt (right side & short puck) 
              (1) 10mm x 1.25 x 70mm bolt (left side & long puck)

Add to Cart:

  • Model: AFP-26
  • Shipping Weight: 1lbs
  • 1 Units in Stock
  • Manufactured by: Pro-tek

This product was added to our catalog on Wednesday 14 January, 2015.

Your IP Address is:
Copyright © 2021 GotTheParts4U. Powered by Zen Cart